基于琼斯法的高亮度积分球定标光源

针对目前光学口径不断增大的空间光学遥感器实验室辐射定标的需求,基于琼斯法设计了一种在400~900 nm波段积分辐亮度为6 800 W/(m2·sr)的高亮度积分球定标光源。对该光源的热设计表明:采用水冷散热的方式能够满足高亮度积分球定标光源的散热需求。实验表明,该定标光源在400~900 nm波段范围内积分辐亮度达到6 714 W/(m2·sr),经过散热后积分球球体温度场分布满足定标要求,可应用于工程实践。     

Influence of aging time of the starting solution on the physical properties of fluorine doped zinc oxide films deposited by a simplified spray pyrolysis technique

Fluorine doped zinc oxide (FZO) films were fabricated from fresh and aged (4, 8, 12 and 16 days) starting solutions using a simplified and low cost spray pyrolysis technique. The X-ray diffraction study showed that the preferential orientation is along the (0 0 2) plane for all the films irrespective of the age of the solution. The crystallite size calculated using the Scherrer’s formula is comparatively smaller only for the film prepared from the starting solution having aging time 4 days which may be due to the efficient incorporation of fluorine atoms into the ZnO lattice. This phenomenon is confirmed by the minimum resistivity value (3.14 × 10⁻² Ω cm) obtained in this particular case. The visible transmittance and the optical band gap values are found to be in the range of 63–83% and 3.20–3.31 eV, respectively. The optical transmittance is found to decrease gradually as the aging time of the solution increases and the optical band gap is found to be slightly higher in the case of the film prepared from the fourth day solution. The scanning electron microscopy results depicted that the microstructure of ZnO:F films are largely influenced by the aging of the starting solution.     

积分球内的铷原子激光冷却

研究了积分球内激光冷却原理,设计积分球时对积分球的反射率、尺寸及球上开孔大小对于激光冷却的影响进行了讨论. 进行了积分球冷却⁸⁷Rb实验,实验结果表明积分球有效的冷却了球腔中的铷原子,获得了积分球内冷原子的吸收信号以及冷原子随冷却光失谐的变化曲线. 关键词： 漫反射光场 积分球 全光冷却     

A non-standard auxiliary integrating sphere and correction method for the realization of diffuse reflectance

To realize spectral diffuse reflectance scale in 0/d geometric condition at National Institute of Metrology in China (NIM), a facility based on a non-standard auxiliary integrating sphere method with special structure has been built up and a correction method for the influence on the thickness of PTFE (polytetrafluoroethylene) coating at the port of auxiliary integrating sphere is mainly discussed. The uncertainty of spectral diffuse reflectance in NIM is approximately 0.25% (k = 2) in 380–800 nm. This facility has been used to establish China diffuse reflectance scales in the VIS–NIR part of the spectrum. This system and correction method presented in this paper can be easily implemented on most commercial spectrophotometers with a lower cost.     

空间调制干涉光谱成像仪星上定标系统研究

经计算推导和实验,研究设计了空间调制干涉光谱仪的星上定标系统,并进行了实验室光谱测试和航天元件的多种环境测试.解决了空间调制干涉光谱仪星上定标技术的关键组件定标光源、光谱滤光片、积分球组件的技术难点.实现了全孔径、部分视场的相对光谱定标,得到了星上定标光谱和干涉图.     

Energy of formation for and liquid binary alloys

We have investigated the free energy of formation for Ag_xIn_1-x and Ag_xSn_1-x liquid binary alloys at temperatures 1173 and 1250 K, respectively. A microscopic theory based on the first order perturbation has been applied. The interionic interaction and a reference liquid are the fundamental components of the theory. The interionic interaction is described by a local pseudopotential. A liquid of hard spheres (HS) of two different effective diametres and charges is used to describe the reference system. The results of the calculations for energy of formation agree very well with the available experimental data. Our calculations also reveal that a simple perturbative approach along with appropriate effective pair potentials can produce nearly quantitative results for the concerned alloys.     

Degradation process in organic thin film devices fabricated using P3HT

The stability of regioregular poly(3-hexylthiophene 2,5-diyl) (P3HT) thin films sandwiched between indium tin oxide (ITO) and aluminium (Al) electrodes have been investigated under normal environmental conditions (25°C and RH∼45–50%). Electrical and optical properties of ITO/P3HT/Al devices have been studied over a period of 30 days. Mobility μ of the order of 10⁻⁴ cm²/V-s has been obtained from the V ² law in the as-deposited P3HT films. Scanning electron microscopy (SEM) investigations show blistering of Al contacts in devices with a poly(3,4-ethylenedioxythiophene) (PEDOT) interlayer on application of voltage whereas no blistering is seen in devices without PEDOT. The results have been explained in terms of trap generation and propagation and the moisture-absorbing nature of PEDOT.      

Spherical harmonics MUSIC versus conventional MUSIC

With the three-dimensional symmetry and wide potential application, spherical array signal processing has been a hot research area for years. This paper devotes to the direction-of-arrival (DOA) estimation of the spherical arrays. Based on the orthogonality of the sensors’ location, MUSIC algorithm in spherical space is proposed, named as SH-MUSIC. Similar to beamspace MUSIC, spherical harmonics transformation is operated before MUSIC algorithm and a better performance is gotten because SH-MUSIC utilizes the array configuration’s orthogonality. On account of the transformation matrix’s orthogonality, spherical harmonics transformation is suggested to be operated firstly in other improved MUSIC algorithms without rejection, and it is demonstrated in beamspace MUSIC. In addition, owing to the tiny error between the steering vectors and the spherical harmonics with high order, sphere array data models including open sphere and rigid sphere are constructed. Simulation proves SH-MUSIC to be effective. Moreover, experimental data from a rigid sphere microphone array is dealt with by SH-MUSIC and the DOAs are estimated accurately.     

Estimation of the degree of asphericity of a glass sphere using a vectorial shearing interferometer

The degree of asphericity is estimated by determining the average radius of curvature in different sections, at various points on the surface of a sphere, and the deviation from it. We employ the vectorial shearing interferometer (VSI) as the instrument to determine the radius of curvature from two subapertures of the transparent glass sphere. We incorporate the sphere as a thick lens into the interferometric setup, illuminating it with an expanded beam. The spherical aberration, introduced by the sphere in the wave front, depends on the local sphere radius, on the refraction index of the glass, and on the cone angle of the source. The wave front aberrated by the sphere impinges on the VSI. Here, the wave front is divided in two in amplitude, it is sheared vectorially, and it is superimposed with itself. The fringe pattern is formed in the intersection of the wave fronts. The shape of the resulting fringe pattern is directly related to spherical aberration. We estimate qualitatively the degree of asphericity, comparing the phase gradients in different sections of the sphere. Here, we report on the experimental setup to test the asphericity, the results with different vectorial shearing (magnitude and direction). Finally, we perform a comparison with the theoretical predictions.